FOREVER Laser Dark Printable, No-Weed Toner Transfer Media

Only Sold in Sets of 100 A & B Sheets > Forever Laser-Dark (No-Cut) LowTemp is a NO WEED, 2-step, full colour heat transfer system designed for use with OKI white toner and CMYK toner printers.

Step #1: A-FOIL
A clear transfer foil that is printed on matte side. Once this sheet is printed, it is then heat pressed together in Step#2 with the Adhesive B-Paper at 305F for 1:20 seconds to create the final transfer image.

Step #2: B-PAPER
Adhesive B-Paper acts as both an opacity layer and the adhesive back for the printed A-Foil. The adhesive coating on the B-Paper only sticks to the areas on the A-Foil where toner is present, after being heat pressed together under firm pressure for 1:20 seconds at 305 degrees. Peel the A-Sheet from the B-Sheet while still very hot. If it is difficult to peel, the sheet can be re-presed for a few seconds to heat it up again. Once finished the final image can then be pressed on to the cotton garmet at 305F for 30 seconds. For a full range of pressing temperatures by material type, please consult the Printing Instructions sheet.

Finishing Steps
As a final finishing step, the finish of your graphic can be changed by pressing for an additional 30 seconds with the Matte or Gloss Finishing Sheet or Hot Stamping Foil. Should recommended heat, pressure and time settings not be followed, print quality will very.

The 2-Paper-Toner Print System from FOREVER provides brilliant colours and consistant results with no mask, no weeding or extra tools required!

30-40 washes before significant signs of wear based on these factors:

• Wash articles inside out
• Max 40 °C or 105 °F water temperature
• Low spinning cycle (800 cycles/min)
• Powder detergent is preferred, however you can also use liquid detergent
• No tumble dry -- hang dry only